Recording a ride with your phone means using its location and motion sensors to log a ride's route, speed, lean and g-force. No separate device is needed; the phone sits on the handlebar and records in the background. This post explains where those numbers come from and what they tell you.
Ridebase GO's ride recording and Rider Report are on the rider app page.
What does the phone measure?
A phone has three sources for this:
| Source | What it gives | Where it struggles |
|---|---|---|
| Location (GPS) | Route, distance, speed | Tunnels, narrow valleys, between tall buildings |
| Accelerometer | Acceleration, braking, cornering force | A loose mount, vibration |
| Gyroscope | The bike's rotation and lean | A phone that sits differently on every ride |
The three work together. Location says where you are; the motion sensors say what the bike is doing at that moment.
Speed
Speed is calculated from location and is usually a little lower than the figure on your dash. Motorcycle speedometers tend to read slightly high, so a gap of a few kilometres per hour is normal.
Top speed on its own says little. The speed profile says more: how speed changed over the ride. A flat line is a motorway; a line that keeps rising and falling is a twisty road or town. If you rode the same road on two days, putting the two profiles side by side shows which day flowed better.
Lean
Lean angle is how far the bike tilts from upright. The faster you enter a corner, or the tighter the corner, the more you lean.
Keep two things in mind when reading the number. First, lean is not a measure of success. Taking the same corner with less lean usually means you chose a better line. Second, grip depends on the surface, the temperature and the state of the tyre; an angle that is comfortable on dry tarmac is not comfortable in the wet or on cold tyres.
As rides add up, the useful question is this: do I lean about the same in right-handers and left-handers? Most riders have a stronger side and don't notice until they look at a recording.
G-force
G-force says how hard your speed or direction changed. 1 g is the force with which gravity holds you to the ground. On a motorcycle it shows up in three places:
- Accelerating, you are pushed back.
- Braking, you are pushed forward.
- Cornering, a sideways force builds; lean balances it.
Braking is the most instructive of the three. Two rides that stop at the same point from the same speed leave different shapes: one a short, sharp peak, the other a long, low curve. The second means the brakes went on early and gently. A sudden, high braking peak usually means you saw something late.
Why the numbers aren't always right
A phone wasn't designed as a measuring instrument; the quality of the reading depends on how it's carried.
- The mount must be solid. In a loose mount the phone shakes by itself, and that shake is recorded as the bike's movement.
- The phone should sit in the same place every ride. Lean is calculated relative to how the phone sits.
- A pocket gives a rougher recording. Route and speed still come out right; lean and g-force get mixed with your body's movement.
- Location drops in tunnels. Recording resumes at the exit; the part in between is an estimate.
So don't read too much into one number from one ride. What means something is how rides made with the same phone and the same mount compare with each other.
What Ridebase GO does with it
You start the ride; Ridebase GO records the rest. When the ride ends, your speed profile, deepest lean and highest g-force are on one screen.
As rides add up, your Rider Report takes shape. It doesn't grade you or call anything good or bad; it describes how you ride. If something makes you curious, you can ask Nero, the companion inside the app.
With the phone on the handlebar, crash detection works too: if you don't answer within 60 seconds of a possible crash, your emergency contacts are told.
The first requirement for a good recording is a solid mount. That is covered in the mount and vibration post.